12
11 Commissioning
WARNING
Risk of injury due to uncontrolled movements
Risk of injury in the event of uncontrolled movement of the product when the power supply is connected.
►
Switch off the energy supply of the machine before any work.
►
Switch off the power supply to the machine before carrying out any work.
►
Secure the power supply against being switched on unintentionally.
►
Please note that the product can still move after an emergency stop.
NOTICE
►
Only operate the product throttled by the air flow control valve.
INFORMATION
The product is delivered as standard without shock absorbers.
►
Refer to our website for information about suitable shock absorbers.
11.1 Adjusting the swivel angle
The product can achieve a swivel angle of 90°. The swivel angle can be readjusted by +/-3° per end stop via the stop
screws.
NOTICE
Shock absorbers may not be used as an end stop.
►
Make sure that the stop screws come into contact with the respective stop surfaces.
►
Reset the shock absorber when you change the swivel angle.
►
Perform the following steps for both stop
screws.
1
2
1
2
►
Loosen the lock nut.
►
Swivel the product to the desired position by
hand.
►
Screw the stop screw in or out to specify the
swivel angle.
►
Tighten the lock nut.
1
Stop screw
2
Lock nut
Zimmer GmbH • Im Salmenkopf 5 •
77866 Rheinau, Germany •
+49 7844 9138 0 • www.zimmer-group.com
INSTALLATION AND OPERATING INSTRUCTIONS:
SWM1000
DDOC00964 / a
EN / 2023-01-13
Содержание SWM1000 Series
Страница 2: ......
