Zimmer SWM1000 Series, Инструкция по установке и эксплуатации

Страница: 14 / 17

14
11.3.1 Adjusting the shock absorber for the 0°/90° position
►
Perform the following steps for both shock absorbers.
1
2
3
► Switch off the power supply.
►
Swivel the product to the desired position by hand.
►
Loosen the lock nut.
►
Rotate the shock absorber clockwise until the connecting plate
moves.
Ö
The piston rod of the shock absorber is pushed in as a result.
►
Unscrew the shock absorber counterclockwise one turn.
Ö
Damping is attenuated.
Ö
The shock absorber is set to maximum effect.
► Loosely attach the lock nut.
► Remove persons and objects from the swivel range.
►
Switch on the power supply.
►
Slightly open the adjustment screw of the flow control valve.
►
Apply compressed air to the product.
► Check the function.
►
Readjust the settings to the flow control valves and the shock
absorbers as required.
►
Tighten the lock nut.
1
Limit stop
2
Lock nut
3
Shock absorber
11.4 Setting the sensors
NOTICE
To ensure reliable sensing, only those sensors sold by Zimmer GmbH and listed as accessories may be used.
► Note that switching point shifts may occur if the sensors are exposed to an additional, external magnetic field.
INFORMATION
►
More information can be found in the installation and operating instructions of the sensor.
Zimmer GmbH • Im Salmenkopf 5 •

77866 Rheinau, Germany •

+49 7844 9138 0 • www.zimmer-group.com
INSTALLATION AND OPERATING INSTRUCTIONS: SWM1000
DDOC00964 / a
EN / 2023-01-13