DDOC00188
enu / 2016-08-31 / Index a
INSTALLATION AND OPERATING INSTRUCTIONS:
Pneumatic GSI series O-Ring gripper
Zimmer GmbH
●
Im Salmenkopf 5
●
77866 Rheinau, Germany
●
Phone: + 49 7844 9138-0
●
Fax: + 49 7844 9138-80
●
www.zimmer-group.de
6.4
Installing the jaw set
The jaw set consists of 3 component groups.
The expanding and clamping jaws as well as the corresponding wiper are designed differently depending on the size of the O-rings
to be installed.
Type
Image / Description
3 spread jaws each for picking
up and spreading the O-rings
3 clamping jaws each for
clamping the O-rings
(clover shape)
1 wiper each for removing the
O-ring from clamping jaw pins
The following steps must be performed to install the jaw set:
Wiper
►
Insert wiper
2
►
Secure wiper with strength class 8.8 cylinder screws
►
Tighten the screws manually, the wiper must be aligned based on the
clamping jaws
Note:
Before installing the jaw set, both stroke setting rings have
to be turned in opposite directions until the limit stop is
reached to set the smallest possible stroke.
(to do so, see also Chapter 6.3)
2
7
