Z8FMC16100 Series Motor Control Development Kit
Quick Start Guide
QS005406-0111
Page 3 of 15
Step 1. Connect the 3-Phase Motor to the Kit
The 24 V DC 3-phase motor included with the kit features three spade connectors that plug
into spade lugs P1, P2 and P3 on the 3-Phase Motor Control Application Board. Connect
the motor leads to the spade lugs on the 3-Phase Motor Control Application Board as
shown in Figure 2.
Figure 1. MC MDS Board Mounted on 3-Phase Motor Control Application Board
Step 2. Set Switches and Jumpers
For initial setup, configure your jumpers and switches as indicated below.
•
J2, DIS RS232 OUT (shunt not installed)
•
J3, DIS IRDA IN (shunt installed)
•
J4 2-3
•
J5 2-3
•
J6 2-3
•
Switch S1 to the far left position
•
Switch S2 to the RUN position
DBG Connector
Pin 1
MC MDS Board
3-Phase Motor Control
Application Board
