It can prevent water, oil or other contaminants from going into the gas circuit to a certain extent.
Air switch
It is used for protective function. Switch it on when the machine works.
Protective cover
It protects the filter from collision.
3.3 Operation of the cutting machine
Please start cutting with I-PLAS60 according to the following steps.
Connect the power supply and the air supply device
Insert the power cable and connect the air supply circuit. For more details about the electric
requirements and air supply requirements of I-PLAS60, please refer to the “installation and
connection” chapter. The machine well connected is shown as the figure below.
Figure 3-3: Connection of the cutting machine
Turn on the cutting system
Switch the air switch to “ON” position according to the figure below.
Figure 3-4: Operation of the air switch
Turn the switch to the proper position
Firstly, connect the compressed air to the filter. And then, connect the machine to the power
