Zigler Z-2312, Инструкция по эксплуатации

Страница: 29 / 49

OPERATION AND MAINTENANCE MANUAL
Semi-automatic BOV Crimping Machine Z-2312
A0310.01.2312.905.1.EN Page 29/33
7. Maintenance
7.1. General maintenance rules
Label the pneumatic hoses before replacement.
Pliers or pipe clamps usage is not allowed. Piston axle, cylinder, etc. damaged during
dismantling may cause a serious machine failure.
Each part must be cleaned with kerosene or other suitable solvent.
Self-sealing rings and seals should never be mounted dry. Before fitting, they must always
be moistened with pneumatic oil.
7.2. Replacing crimping jaws
To replace the crimping jaws set:
1. Using 8 mm flat key remove the Lower sleeve lock (Fig. 9, pos. 2).
2. Using the correct end of special double-end key 9312.46.004.0 delivered with the machine,
unscrew and remove the lower sleeve unit (along with can sealing and the nut) - Fig. 9,
pos. 1 + pos. 3 + pos. 4. The lower sleeve has holes cut from the bottom for the pins of the
key.
3. Using the smaller end of special double-end key 9312.46.000.0 delivered with the machine,
unscrew the inner adjustment sleeve [Fig. 9, pos. 6] along with the BOV valve sealing [Fig.
9, pos. 5].
4. Using the so-called “lamellar key” 9002.46.002.1 delivered with the machine, loosen (do
not unscrew completely) the crimping jaws [Fig. 9, pos. 8] with the mounting sleeve [Fig. 9,
pos. 10]. Position the key as shown on Fig. 15.
Fig. 15. Proper placing the lamellar key 9002.46.002.0, the lamella is located between the segments of
crimping jaws.
5. Insert additional arbor (Fig. 9, pos. 9) inside the crimping jaws, grab the crimping jaws with
hand and unscrew manually the crimping jaws along with mounting sleeve. Inserting