ZIEHL-ABEGG ZAS0, Инструкция по эксплуатации

Страница: 19 / 72

6 Start-up
6.1 Operating conditions
" The drive must be installed in a not free accessible machine room or a closed hoistway.
" Be aware of the protection class speci fi ed on the name plate.
" Do not operate the motor in an explosive atmosphere.
" The ambient temperature may be within 0 ° C and +40 ° C.
" Maximum permissible humidity 95 %, not wet.
" Reduced motor output when installed 1000 m above sea level by 1 % per 100 m.
" Please contact ZIEHL-ABEGG SE in case of orders deviating from the corresponding applica-
tion conditions.
6.2 First-time start-up
Before fi rst-time start-up, check the following:
" Installation and electrical connection have been properly completed.
" Safety devices are installed.
" Installation waste and foreign bodies have been removed from the danger area.
" The protective earth is connected.
" Motor protection correctly connected and operative.
" Cable entries closed.
" The oil drain opening has been properly sealed.
" Mounting, installation position and accessories are o.k.
" The gearbox housing is secured against moving by stops and set screws in case of lateral or
inclined cable pull.
" Connection data corresponds to the data on the name plate.
Warning!
" Separately delivered traction sheave and/or cable pulley must be installed properly (see chapter
"Maintenance and service – changing the traction sheave").
" If the machine has been dismantled for weight, transport or space reasons, the dismantled parts
must be reassembled in their original state and the fastening parts secured with the appropriate
tightening torque (see chapter "Maintenance and service – tightening torques and strength
values").
6.3 Operation
During operation, the drive must be checked for:
" increased operating temperature
" unusual noises
" possible oil leaks
CAUTION!
Caution!
" If irregularities are discovered during operation, the drive must be shut down immediately and
the cause of the fault determined (see chapter "Faults, causes and remedies").
The fault table lists possible faults, their causes and suggested remedies. If the cause cannot be
found or it is not possible to repair the fault by your own means, please consult the after-sales service.
CAUTION!
Caution!
" If the safety brake (if available) is opened before starting a ride, no further ride may be started.
An appropriate signal must be sent to the lift control by the micro switch on the safety brake.
6.4 Drive approval test
Half load test
The lift must be easily movable in both directions by the hand wheel when the brake is open.
Half load test (alternative):
With half load the motor current has to be measured in up and down direction. Mostly this is possible
at the VVVF. (Please see operating instructions of your VVVF). The measured currents should not
divert by more than 10 %.
2ULJLQDORSHUDWLQJLQVWUXFWLRQV
ZAS0 Start-up
A-TBA11_06-GB
Part.-No. 01008051-GB
19/72