ZIEHL-ABEGG ZAS0, Инструкция по эксплуатации

Страница: 6 / 72

" Spare parts must always meet the technical requirements speci fi ed by the manufacturer. This is
always guaranteed in the case of original spare parts.
" Keep the prescribed intervals or intervals speci fi ed in the operating manual for periodic inspec-
tions.
" Workshop equipment suitable for the work is necessary for carrying out maintenance measures.
" Work on the drive may only be performed by reliable, trained or instructed personnel. The
responsibilities for the operation, set-up, maintenance and repair must be clearly allocated.
Observe the legally admissible minimum age.
" Work on electrical equipment of the drive may only be performed by a quali fi ed electrician or an
instructed person under the control and supervision of a quali fi ed electrician in accordance with
electrical engineering rules.
" Installation, connection to the power supply and commissioning may only be performed by
quali fi ed service personnel ! The relevant regulations must be observed!
" Planners, manufacturers and operators of system parts or entire systems are responsible for the
correct and safe mounting and a reliable operation.
2.5 Safety instructions for certain operating phases
2.5.1 Mounting
" Always wear personal safety equipment for installation work because sharp-edged parts can
cause cutting wounds among other things.
2.5.2 Normal operation
" Refrain from working in any way which is detrimental to safety.
" Take measures to ensure that the drive is only operated in a safe, perfect working order.
" Only operate the drive when all the protective devices and safety-related devices are available
and working properly.
" Shut down and secure the lift immediately in the event of malfunctions!
Always have faults eliminated immediately.
2.5.3 Maintenance and repair
" Cordon off the maintenance area widely insofar as necessary.
" Switch off the machine completely and secure it against switching back on unexpectedly for
maintenance and repair work.
" Single parts and larger sub-assemblies must be fastened and secured carefully to lifting gear so
that they do not pose a threat. Only suitable and technically perfect lifting gear and load handling
devices with a suitable load capacity may be used. Do not stand or work underneath suspended
loads.
" When performing overhead installation work, use the climbing aids and work platforms provided
or others with approved safety. Wear fall protection when performing maintenance work at a
great height.
" Keep all handles, steps, railings, podiums, platforms and ladders free from dirt, snow and ice.
" Clean oil, fuel or care agents from the drive and especially the connections and screwed joints
before beginning maintenance or repairs. Do not use aggressive cleaning agents.
" Before cleaning the drive with water or other cleaning agents, close all openings which may not
be penetrated by water, steam and cleaning agents for safety and functional reasons. Electric
motors and switch cabinets are especially at risk.
" After cleaning the closed openings are opened completely.
" Re-tighten screw connections that were loosened during maintenance and repair work, if
necessary with a torque wrench, see chapter “ Maintenance and Service – Torques and Strength
Values. ”
" Make sure that operating and auxiliary materials are disposed of in a safe and environmentally
friendly way.
2ULJLQDORSHUDWLQJLQVWUXFWLRQV
ZAS0 Safety instructions
A-TBA11_06-GB
Part.-No. 01008051-GB
6/72