Information
Detail information to the topic "auto addressing" (R-TIL10_17) can be requested over our
support department for control systems - ventilation engineering (V-STE).
3.3 Maintenance
The device must be checked for soiling and, if necessary, cleaned in periodic intervals.
3.4 Transport
•
The device is packed ex factory to suit the transport method previously agreed.
•
Always use the original packaging materials when transporting the device.
•
Avoid shocks and impacts to the device during the transport.
•
During manual handling the human lifting and carrying restrictions must be
observed and adhered to.
3.5 Storage
•
The device must be stored in its original packaging in a dry and weather-proof
room.
•
Avoid exposure to extreme heat and cold.
•
Avoid over-long storage periods (we recommend a maximum of one year).
3.6 Waste disposal / recycling
Disposal must be carried out professionally and environmentally friendly in accordance
with the legal stipulations.
4 Mounting
4.1 General notes
Attention!
The following points must be complied with during the mechanical installation to avoid
causing a defect in the device due to assembly errors or environmental in
uences:
•
Before installation remove the device from the packing and check for any possible
shipping damage!
•
The installation in a switch cabinet or in a adequate plastic housing will be made
through a snap-up on a 35 mm top-hat-rail (EN 50 022) or through screw fasten-
ing.
•
Do not allow drilling chips, screws and other foreign bodies to reach the device
interior!
•
Do not mount equipment on vibrating base!
•
Care must be taken to avoid direct radiation from the sun!
Operating Instructions
NETcon
–
model series DIG-9NE
Mounting
L-BAL-E134-GB 1118 Index 001
Part.-No. 00163363-GB
8/21
