30
31
Direct connection: Connect the camera and computer by network connecting cable.
Internet connection mode: Connect the camera to Internet by Router or Switch and
user can log in the device by browser.
Note: Please do not put the power and network cable in places where can be easily
touched to prevent video quality lowered by unstable signal transmission due
to poor contact of cables.
The computer must have the network segment where the camera IP address belong
to. The device will not be accessible if without the segment. I.E. The camera default
IP address is 192.168.5.163,then segment 5 must be added in the computer. Specific
steps are as below:
Firstly open the window of Local Area Connection Properties on computer, select
the “Internet protocol version 4(TCP/IPv4)” as shown by picture on the left. Double
click or click the property “Internet” protocol version 4 (TCP/IPv4)to enter into the
Internet Protocol Version 4(TCP/IPv4) Properties window,select “Advanced” to enter
into the Advanced TCP/IP Setting and add IP and subnet mask in the IP browser as
picture shown below. Click the “Confirm” to finish the adding of IP segment. User
can add the corresponding network segment according to the revised IP address of
the camera.
4.1 Connecting Mode
4.Network Connection
Note: The IP address to be added cannot be same with that of other computers or
devices.The existence of this IP address needs to be verified before adding.
!"#$
Information and Communication PTZ Camera
!"#$
Information and Communication PTZ Camera
