48
Parameter
Description
You can set this parameter only when
Port Mode
is set to
PTZ Control
.
When
INTERNAL-PTZ
is selected, this parameter is always set to
Built-in PTZ Priority
,
and it is unnecessary to connect the camera to an external PTZ through the serial port.
Control through the external PTZ is not effective even when the camera has been
connected to an external PTZ.
Set this parameter as required. Make sure PTZ control related interfaces are correctly
connected.
Address Code
Set the address code for the PTZ.
Note
:
You can set this parameter only when
Port Mode
is set to
PTZ Control
and
PTZ Protocol
is
not set to
INTERNAL-PTZ.
3.
Click
Save
.
Transparent channel
Use the RS485 serial port to achieve transparent data transmission with the third-party device.
1.
Click
Setup
>
System
>
Ports & Devices
, and then click the
Serial Port
tab.
2.
Select
Trans-Channel
from the
Port Mode
drop-down list.
3.
Click
Save
.
OSD
To display information from the third-party device on the OSD, you need to select OSD as the port mode.
The camera receives information from the third-party device through the RS485 serial port, translates the
received information, and then displays it on the OSD.
NOTE!
To enable the camera to correctly translate information received from the third-party device, make sure
that the information sent by the third-party device through the serial port complies with the data format
specified by our company. For more details, contact your dealer.
1.
Click
Setup
>
System
>
Ports & Devices
, and then click the
Serial Port
tab.