Zgonc Yellow Profi Line YPL 500, Перевод с оригинального руководства пользователя

Страница: 18 / 40

18 GB
18 Replacing the power cable
– To prevent hazards, leave the replace-
ment of damaged power cables strictly
to the manufacturer or a qualified
electrician. There is a risk of electric
shock!
19 Inflating tires
– Directly after inflating tires, check
the pressure with a suitable pressure
gauge, for example at your filling sta-
tion.
20 Roadworthy compressors for building
site operations
– Make sure that all lines and fittings are
suitable for the maximum permissible
operating pressure of the compressor.
21 Place of installation
– Set up the compressor on an even
surface.
ADDITIONAL SAFETY INSTRUCTIONS
Safety instructions for working with
compressed air and blasting guns
•
The compressor pump and lines can be-
come very hot during operation. Touching
these parts will burn you.
•
The air which is sucked in by the com-
pressor must be kept free of impurities
that could cause fires or explosions in
the compressor pump.
•
When releasing the hose coupling,
hold the hose coupling piece with your
hand. This way, you can protect yourself
against injury from the rebounding hose.
•
Wear safety goggles when working with
the blow-out pistol. Foreign bodies or
blown off parts can easily cause injuries.
•
Do not blow at people with the blow-out
pistol and do not clean clothes while be-
ing worn. Risk of injury!
Safety information for paint spraying
•
Do not process any paints or solvents
with a flash point below 55° C. There is
a risk of explosion!
•
Do not heat up paints or solvents. There
is a risk of explosion!
•
If hazardous liquids are processed, wear
protective filter units (face guards). Also,
adhere to the safety information provid-
ed by the manufacturers of such liquids.
– Only use cable reels in the unrolled
state.
13
Remain attentive
– Pay attention to what you are doing.
Remain sensible when working. Do
not use the electric tool when you are
distracted.
14
Check the electric tool for potential
damage
– Protective devices and other parts
must be carefully inspected to ensure
that they are fault-free and function as
intended prior to continued use of the
electric tool.
– Check whether the moving parts
function faultlessly and do not jam or
whether parts are damaged. All parts
must be correctly mounted and all
conditions must be fulfilled to ensure
fault-free operation of the electric tool.
– Damaged protective devices and parts
must be properly repaired or replaced
by a recognised workshop, insofar as
nothing different is specified in the
operating manual.
– Damaged switches must be replaced
at a customer service workshop.
– Do not use any faulty or damaged
connection cables.
– Do not use any electric tool on which
the switch cannot be switched on and
off.
15
Have your electric tool repaired by a
qualified electrician
– This electric tool conforms to the ap-
plicable safety regulations. Repairs
may only be performed by an electri-
cian using original spare parts. Other-
wise accidents can occur.
16 Important!
– For your own safety you must only
use the accessories and additional
units listed in the operating instruc-
tions or recommended or specified by
the manufacturer. The use of mounted
tools or accessories other than those
recommended in the operating in-
structions or catalog may place your
personal safety at risk.
17 Noise
– Wear ear muffs when you use the
compressor.