ASSEMBLY GUIDE
10
Legs not working
Possible Cause
Remedy
Ξ Power Cable is not connected
Ξ Legs are not connected
Ξ Poor plug contact
Ξ Control Unit is defective
Ξ Remote Control is defective
Ξ Plug the Power Cable into the Control Unit
Ξ Plug the Motor Cables into the Control Unit and Legs
Ξ Check all connections
Ξ Replace the Control Unit
Ξ Replace the Remote Control
7. Troubleshooting
Possible Cause
Remedy
Ξ Mains power breakdown or main power is plugged off
during movement
Ξ Control Unit is defective
Ξ Remote Control is defective
Ξ Leg is defective
Ξ Zero setting (if movement is only possible downwards)
Ξ Replace Control Unit
Ξ Replace the Remote Control
Ξ Replace the Leg
Legs only operating in one direction
Possible Cause
Remedy
Ξ Power Cable is not connected
Ξ Remote Control is not connected
Ξ Control Unit is defective
Ξ Power Cable is defective
Ξ Remote Control is defective
Ξ Poor plug contact
Ξ Exposed to liquids
Ξ Plug the power cable into the control unit
Ξ Plug in the remote control
Ξ Replace the Control Unit
Ξ Replace the Power Cable
Ξ Replace the remote control
Ξ Check all connections
Ξ Replace the remote control
Control Unit or Remote Control is not working
7.2 Error messages & Error code (Only on external remote with display)
The display reads HOT.
Possible Cause
Remedy
Ξ The control unit is fitted with overheating
protection. Overheating has caused it to
stop the control unit
Ξ Wait until the control unit has cooled down and HOT is no longer displayed. The
control unit is then operational again
The display reads E + an error code
NOTE: (If different error code than shown below, contact customer service)
Possible Cause
Remedy
Ξ There is an internal fault in the
control unit
Ξ Proceed as indicated in the following list
