ZF Euro Alpi Vezzana, Руководство по эксплуатации и обслуживанию

Страница: 17 / 44

Before switching on the stove, the display appears as shown in
Figure 2.
Figure 2
To turn on the stove, press on P3 for a few seconds. The successful ignition is indicated in the display with
the message "
START" as in (
Figure 3
) and with the ON/OFF LED flash. This phase lasts for a time given by
the parameter PR01. Under these conditions, the stove will go in the state of preheating, the ignition turns
on (shown by the ignition LED) and so does the smoke extractor. Malfunctions during the ignition phase are
shown on the display and the stove
goes into an alarm state. (refer to
chapter 12).
Figure 3
10.2 Pellet loading
After about 1 minute, the pellet loading phase begins, the message " LOAD PELLET" passes on the display
and the ON/OFF LED flashes. In a first step the auger provides to load the pellets in the brazier for a time
given by the parameter PR40 (auger LED on), the speed of the fumes is defined by parameter PR42 and the
ignition is always on (ignition LED on). In the second phase, after the time of the parameter PR40 has
passed, the auger turns off (auger LED off) for a time given by the parameter PR41, while the speed of the
fumes and the ignition remain in the previous state. If the stove does not turn on after this phase, the auger
turns on for a period given by the parameter PR04, the fumes speed is given by the parameter PR16 and the
ignition is on. (
Figure 4
).
Figure 4
off
START
LOAD PELLET