ZF Euro Alpi Vezzana, Руководство по эксплуатации и обслуживанию

Страница: 19 / 44

10.5 Change of the heating power set
During the normal operation of the stove (Work) you can change the heat power output by using the
buttons P2 (LED set power on). Press P2 again to increment the heating power, while press P1 to decrement.
The power level set is shown on the display. (
Figure 7
) To exit from the menu wait 5 seconds without
performing any operation on the keyboard, or press P3.
Figure 7
10.6 Changing the room temperature
To change the room temperature it is enough to act on the button P1. The display shows the set room
temperature (SET temperature). Thus acting on the buttons P1 (decrease) and P2 (increase) it is possible to
change the value. After about 5
seconds the value is saved and the
display returns to the normal
mode, or press P3 to exit. (
Figure 8
).
Figure 8
10.7 The room temperature reaches the set temperature
(SET temperature)
When the room temperature has reached the set value, the heating power of the stove is automatically
decreased to the minimum value. Under these conditions, the display shows the message
"MODULAT-" (
Figure 9
). If the room temperature decreases below the set one (Set temperature) the stove
goes back to "Work" mode and to the power previously set (Set power).
Figure 9
Pow 3
22,5°
c
Modulat-