ZETRON 025-9623 D3, Руководство пользователя

Страница: 28 / 55

Configuring the Digi One SP Device
28 025-9623 D3
gateway 192.168.25.2
DNS serv [none]
Domain [none]
Host name [none]
Scenario Outgoing Network Connection/
Outgoing TCP Connection
♦ Connecting the Digi One SP to the network
1. Remove the modules from their packing and confirm that their DIP switches are
set to EIA-232 (see Figure 6 ).
2. Locate the MAC address printed on the bottom line of the factory label on Digi
One SP module. Write this number down because you will need it during the
initial setup. (It is labeled “MA: xxxx:xxxx”.)
3. Install the loopback device supplied with the unit on the serial port D-connector
of the Digi One SP.
4. Plug the power supply into the module and then into a wall socket. Do not expect
the power LED to come on right away.
5. Plug the Ethernet cable into the RJ-45 jack on the module and plug the other end
of the cable into any available port on the network. This must be the same
network that serves the PC you intend to use for configuring the module and in
which the module will be used. The port used does not need to be the port to
which the module will finally end up connected.
The Power and Link LEDs should both be on at this point.
♦
Performing the initial configuration using the Digi software tool
1. Insert the CD-ROM into the disk drive and close the drive. If the top screen for
the utilities does not start automatically, use the
RUN
option on the
START
menu.
2. From the opening screen, select the Digi Device Setup Wizard. The opening
screen of the wizard will look like the following. Click
Next
.