Zero88 Jester, Руководство по эксплуатации

Страница: 18 / 65

JesterML Operating Manual Program Mode
18 of 65 73-406-00 Issue 1.0
3. Use the cursor up or down buttons to select the step to overwrite.
4. Press the EDIT button if you wish to load the existing contents of the step. The
LED in the EDIT button will come on.
5. Use the fixture controls (and PRESET faders on the JesterML24) to set the
required output levels. The output is live.
6. If you used the EDIT button to load the existing step, press it again to save the
changes, and the LED in the EDIT button will go out. Otherwise press the
PROGRAM/GO button to save the changes. The Main LCD asks you if you wish
to overwrite the step, select <Overwrite> and press ENTER. Overwrite can be
forced by holding the PROGRAM/GO button or by using SHIFT+PROGRAM/GO.
NOTES
Adding Steps
A new step cannot be added until the current step has been saved by pressing
PROGRAM/GO
Renumbering Steps
Any original steps in a Chase after an inserted step will be renumbered accordingly.
For example, if you started with a 10 step Chase and added a step between steps 4
and 5, the new step becomes step 5 and the original steps 5 - 10 become steps 6 -
11. Any steps in a Chase after a deleted step will be renumbered accordingly. For
example, if you start with a 10 step Chase and delete step 5, original steps 6 – 10
become steps 5 - 9.
Inserting Steps
The INSERT button can only insert a step after the current step. If you wish to insert
a step before Step 1 of a Chase then following actions must be performed: Select
Step 1 and press the EDIT button. Insert a new step after Step 1 using the INSERT
button. Press the PROGRAM button to save the contents of Step 1 to the new Step
2. Set up the new look for Step 1, and re-program it using the PROGRAM button.
Deleting Last Step
If there is only one step in the chase, it will be automatically converted to a scene
memory. The last step should be deleted in the same way you would delete a
normal scene.
Maximum Steps Programmed
If an attempt is made to insert a step into the Chase when the maximum 999 steps
have been programmed, the Main LCD displays a warning. The chase and outputs
are unaffected.
Deleting a Chase Memory
1. Use the cursor up or down buttons to select the chase memory to be deleted.
2. Press and hold SHIFT with the CLEAR button for 1 second. The memory will
change to an unprogrammed scene memory.
Deleting a Chase Submaster (JesterML24 only)
1. Press the CHANNEL FLASH button under the Submaster you wish to clear.
2. Press and hold SHIFT with the CLEAR button for 1 second. The Submaster will
be cleared.