BNP
®
6012 and 7212 SUCTION BLAST CABINETS
Page 26
© 2019 CLEMCO INDUSTRIES CORP.
www.clemcoindustries.com
Manual No. 27723, Rev. B 04/19
7.9.28
Attach the inlet-pipe adaptor, replacing the
gasket if worn, compressed, or otherwise damaged.
7.9.29
If the lower flange gasket (usually installed on
the hopper flange) is worn, compressed, or otherwise
damaged, clean old gasket material from the flange and
install new 2" strip gasket to the reclaimer hopper flange.
7.9.30
Reattach the reclaimer body to the hopper and
leg assembly.
7.9.31
Install flex hoses.
7.9.32
Allow time for the caulking to cure before putting
the reclaimer in service.
7.10
Removing or Replacing Reclaimer Inlet Baffle
Figure 31
When using lightweight media such as agricultural
media or very fine media (180 and finer), as noted in
Paragraph 1.9.6, good media may be carried over to the
dust collector. To prevent lightweight-media carryover,
the reclaimer inlet baffle can be removed. Review the
following process before beginning to make sure all
parts are available:
Installation Notes:
Make sure enough 13089 - 2" adhesive-backed gasket
is available to replace compressed or damaged gaskets
on the reclaimer upper flange (and lower hopper flange if
the hopper is removed from the reclaimer).
900 cfm requires 7 feet at each flange.
1200 cfm requires 8 feet at upper flange and 7 feet
at lower flange.
Depending on conditions such as height and
accessibility, it may be easier to replace the inlet baffle if
the reclaimer body is removed from the hopper and leg
assembly.
7.10.1
Remove the flex hose from the reclaimer top.
7.10.2
Remove the fasteners securing the reclaimer
top and remove the top.
7.10.3
Remove the two bolts (three on 900 reclaimer)
that secure the baffle to the side of the reclaimer inlet
and remove the baffle through the top.
7.10.4
Remove all caulking residue.
7.10.5
If removing (not replacing) the baffle, remove the
strip gasket from the inner tube and install the baffle
bolts and reclaimer top. If replacing the baffle, skip to
Paragraph 7.10.6.
7.10.6
When replacing the baffle, make sure the strip
gasket on the inner tube is in good condition and install
the new baffle in reverse order. Apply silicone caulk to
the seam (opposite side of the mounting bolts) between
the baffle and reclaimer body. Wipe the caulk smooth.
Figure 31
7.10.7
Inspect the strip gasket on the reclaimer upper
flange; replace it if damaged or compressed.
7.10.8
Install the reclaimer top and allow the caulking
to cure before putting the reclaimer into service.
7.11
Reverse-Pulse Dust Collector
Refer to the applicable dust collector manual, as noted
in Paragraph 1.1.1, for dust collector maintenance.
Reclaimer Top and Inner
Tube. Style may vary
depending on reclaimer size.
2” Strip Gasket
2” Strip Gasket
Baffle
U-Channel
Baffle Nuts and Lock Washers
Baffle Bolts and
Flat Washers
Reclaimer Body
