Zero AEROLYTE PRN 6060-A, Руководство пользователя

Страница: 10 / 33

AEROLYTE 6060A and 7070A G2 PRESSURE CABINETS Page 9
© 2016 CLEMCO INDUSTRIES CORP.

www.clemcoindustries.com

Manual No. 27789 Rev. A, 10/16
3.3.4
Match drill the remaining four bracket holes and
install the remaining fasteners.
3.3.5
Loosen the fasteners on the slotted bracket and
raise or lower the armrest to a comfortable position.
3.4
Track and Turntable Assembly
3.4.1
These instructions cover field installation of the
2000 lb. capacity track and work cart with turntable. If
the track was ordered with the cabinet, it is partially
assembled at the factory. Disregard the instructions that
do not apply. Refer to Figure 9 for arrangement of the
major components.
Figure
9
3.4.2 Install inside track, refer to Figure 10
3.4.2.1
Lay the inside track on the cabinet hoppers and
above the grate as shown in Figure 10.
Figure
10
3.4.2.2
Push the end support bar against the inside
cabinet wall, opposite the door, and insert the angled
tabs on the door end of the track into the two sleeves on
the hopper as shown.
3.4.2.3
Make sure the weight of the track is evenly
distributed over the hoppers and match drill through the
cabinet wall, at the four hole locations in the end support
bar for 3/8 fasteners. If necessary, mark the hole
locations and remove the track for drilling.
3.4.2.4
Secure the inside track to the cabinet with four
3/8-NC cap screw, flat washers, lock washers, and nuts
provided.
3.4.3 Position outside track, refer to Figure 11
3.4.3.1
Place the outside track so it is in-line with the
inside track. Space the track so the top rails (not the
smaller support rails) on the hinged end are approximately
42-inches from the top rails on the inside track.
4 2 - I n c h e s
Figure 11
3.4.4
Attach hinged track, refer to Figure 12
Figure 12
Release Pin (3
)
Inside Track
Outside Track
Release Pin (3)
Workcar
Turntable
Angled
Mounting Tabs
Match Drill
4 bolt holes
Insert angled
tabs into hopper
sleeves.
Hinged Track
Doors and Grates Removed for Clarity
Outside Track
End Support
Bar
Hinged Track
Lay hinged track on inside
and outside track supports
1/2 x 1/2
Shoulder Screw
Stock No. 03491
Quick Release Pin
Stock No. 25540
3/8 Lock Nut
Stock No. 03312
Track Supports
Leveling Foot Pads
Leveling Foot Pads