ZERO-X RAPTURE HD ZX-RHD, Руководство пользователя

Страница: 19 / 24

19
5.3 MOTOR REPLACEMENT GUIDE
The Rapture
HD
uses brushed motors similar to what is used in remote control
cars. These motors do need to be replaced from time to time to keep your
drone up in the air.
The following instructions will take you through how to replace your motors
when they are not working like new. It is recommended that before you
attempt to replace the motors you set up a clean level space.
5.4 ROTOR BLADE REPLACEMENT:
1. Turn the Rapture
HD
upside down and remove the 3 screws in
the motor housing and the screw in the LED window. (Refer
to Fig 5.4.1)
2. Carefully remove the motor housing panel and the LED
window.
(Refer to Fig 5.4.2)
3. Turn the Rapture
HD
right side up and remove the two screws
from the motor. (Refer to Fig 5.4.3)
4. Remove the motor from the bottom of the motor housing.
(Refer to Fig 5.4.4)
5. Remove the adhesive from the motor’s power plug using a
blunt flat instrument to scrape back the adhesive.
(Refer to
Fig 5.4.5)
6. Unplug the motor’s power plug being careful not to pull the socket off the circuit board.
7. Remove the heat sink from the old motor and slip it over the new motor being careful not
to block the new motor’s ventilation hole.
8. Connect orientation (clockwise, counter clockwise). Clockwise
motors will have a red connector socket and will be marked
with the code “CW”, while counter clockwise motors will have
a white connector socket and will be marked with the code
“CCW”.
(Refer to Fig 5.4.6)
9. Slip the motor back into the motor housing making sure
that the screw holes in the top of the motor align with the
screw holes in the motor housing and the teeth on the gears
synchronise.
(Refer to Fig 5.4.7)
*Fig 5.4.1
*Fig 5.4.2
*Fig 5.4.3
*Fig 5.4.4
*Fig 5.4.5
*Fig 5.4.6
*Fig 5.4.7