Zephyr Airdolphin Pro Z-1000 - 48, Инструкция по эксплуатации

Страница: 19 / 28

7. Connecting the System
19
7-1 Before connecting
7-2 Length of the extension cable that leads from the Airdolphin to the battery
The Airdolphin 48V model is used as a standalone system(Off-grid system). A 48V battery is required
for the system. The following explains how to connect the Airdolphin power cable (approx. 500mm
long) and provides a typical example of a wind turbine system connection.
7-3 D.P.D.T.(Double pole double throw) blade switch
To ensure safety, the Airdolphin (Z-1000) is equipped with an emergency stop feature (See page
3). In the event of an emergency stop, the Airdolphin (Z-1000)’s power supply must be shut off
for approximately 10 seconds before being restarted. In order to facilitate turning the power on/
off, Zephyr Corporation recommends the installation of a D.P.D.T. BLADE SWITCH between the
Airdolphin (Z-1000) and the battery. (See next page.)
The Airdolphin is designed based on use of 15meter / 8sq cable between Airdolphin and batteries.
If longer distance is required, please contact the dealer where you purchased the Airdolphin or
Zephyr Corporation.
* Pay attention to the + and – terminals when connecting the
power cable to the battery. Reverse connection will cause
serious damage.
(Be aware that any damage to this product caused by improper connection is NOT
covered by the warranty. Connect the cables to the correct terminals.)
The Airdolphin (Z-1000) has an output voltage of 50V.
Connect either a single 48V battery or four 1V batteries in a serial
connection.