Zephyr Airdolphin Pro Z-1000 - 48, Инструкция по эксплуатации

Страница: 13 / 28

13
6. Assembling the Airdolphin (Z-1000)
6-2 Assembly procedure
Follow steps
j
–
m
below to assemble the Airdolphin (Z-1000). The assembly procedure for each part is
shown on the following and subsequent pages.
l
Always assemble/install the Airdolphin in accordance with the procedure outlined in this manual.
l
Use a tower in which the upper portion has an outer diameter of at least 48.6mm and at least 100mm in length.
l
Do not install the Airdolphin if the pole is not standing straight.
If the Airdolphin is not mounted in an upright position, it could topple or fall, causing injury or damage to the system.
l
Moving roter blades are as dangerous as a sharp object. During installation and maintenance attaching the rotor to
the tower body is extremely dangerous because the wind could blow while the work is being performed, rotating the
rotor and causing a serious accident such as death or injury. After attaching the rotor to the body, fix the rotor in place
to prevent it from rotating until the wind turbine has been completely installed
l
If the wind turbine has not been completely assembled, a strong gust of wind or similar phenomenon may cause it to
fall, causing an injury or other misharps.
OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS DURING ASSEMBLY AND INSTALLATION
l
Failure to observe these safety instructions may result in a severe accident or damage to the Airdolphin (Z-1000) or
other parts of the system.
l
Do not place the Airdolphin body upside down or inclined during installation or maintenance. Water (rain,
snow) can leak inside a body joint gap and cause damage to the turbine. When the body is upside down or
inclined and has the possibility of getting wet, put a cover over the body well.
Warning
(outer diameter is 4 8 .6mm )