Zephyr Airdolphin Pro Z-1000 - 48, Инструкция по эксплуатации

Страница: 16 / 28

16
6. Assembling the Airdolphin (Z-1000)
3. T h e r e a r e f o u r n o t c h e s ,
ranging from large to small,
in the assembly holes on hub
1. On hub , there are four
protrusions, ranging from large
to small. These protrusions
fit into the corresponding
notches, fixing parts securely
into place.
. After attaching the blades, tap them with a rubber mallet or other tool that will not damage them until
they are fixed securely in place. The wind turbine could break if the blades are not securely attached
to hub 1
00
00
01
00
00
01
00
00
0
00 00 03
Hub 1 Attachment Face
0 0
0 0
0 1
0
0
0
0
0
00000
3
Rubber Mallet
(or similar tool)
Hub
Protrusion
(Large)
Hub 1
Protrusion
(Small)
Notch
(Small)
Notch
(Large)
l
Assembling the rotor
1. Attach the three blades to the blade attachment
sections on hub 1. There are numbers on hub
1 and the attachment sections of the blades.
Make sure that these numbers match when
attaching the blades.
Blade Guard Groove
* Attach the blades to hub 1
so that the corresponding
numbers match. Using the
wind turbine with the blades
a t t a c h e d i n t h e w r o n g
locations will result in degraded performance and may
cause damage to the turbine itself.
If the numbers on the supplied hub 1 and the three
blades do not match, contact the dealer where
you purchased the Airdolphin (Z-1000) and have it
exchanged so that the numbers properly.
* The rotor is tuned so that it is dynamically balanced. The
groove on the blade guard contains a clay-like tungsten
substance used for balancing weights. Do not remove
the tungsten material under any circumstances.
00
00
01
0000
01
00
00
0
00
00
0
00
00
03
000
003
Hub 1 Attachment Face
Blade Attachment Section
Hub 1 Attachment Face
There is a protrusion on this part
of the blade attachment face.