Zephyr Airdolphin Pro Z-1000 - 48, Инструкция по эксплуатации

Страница: 15 / 28

15
6. Assembling the Airdolphin (Z-1000)
k
Attaching the tail to the body
1. Line up the attachment holes on the body
and the tail.
. Make sure you have the tail shaft right side
up and then insert it into the attachment hole
on the body until it makes contact with the
bottom as shown in the figure below.
3. Install the screw plug on top of the tail
shaft and then tight it snugly into place.
Tail Attachment Hole
Tail Attachment Hole
Tail Shaft
D-shaped
pedestal
* When the tail shaft is inserted
correctly, the top of the tail
shaft should be approximately
5mm below the uppermost
body surface.
Approx.5mm
Hexagonal Wrench (8mm)
* Tighten the screw plug so that it is completely below the
body surface.
Correct
Incorrect
Screw Plug
4. In order to prevent crrosion, apply silicone sealant to the screw plug from above and ensure that the
screw plug is completely covered.
* Be careful not to apply the silicone sealant to other parts of the body.
Silicone sealant
Cover the screw plug
by applying the silicone
sealant provided with
this product.