Zephyr Airdolphin Pro Z-1000 - 48, Инструкция по эксплуатации

Страница: 18 / 28

18
6. Assembling the Airdolphin (Z-1000)
3. Once the rotor is in place, use the hexagonal
nut to fasten it to the shaft.
4. The rotor will be fixed into place once
the gap between the body and the rotor
reaches 3mm.Verify that the rotor can rotate
smoothly.
5. Holding the rotor in place, use the wrench
included with this product to grip the nub
on the end of the shaft and turn it counter
clockwise. Continue to tighten until the three
plates are quite snug. (Tightening torque
30Nm)
6. Fix the E-ring to the shaft. Use the pliers etc
to fix the E-ring as the below figure.
Wrench
(supplied with
this product)
Rotate counterclockwise.
Rotor
Approx. 3mm
Completely Assembled Unit
7. Check the Rotor that will rotate smothly after
attaching the E-ring to the shaft.
8. Slide the nose cone onto the end of the rotor.
Lining the protrusions on the nose cone up
with the blades, press the nose cone onto the
rotor until in locks into place with a snapping
sound.
E- ri ng
Fix the E-ring as the figure.
E-ring
#To remove E-ring,
u s e s e t s o f f l a t
blade screw driver.
the
two
Nose Cone
Visible gap
No gap
Over 5mm gap
Less than 5mm gap
If the nose cone is not securely attached to the hub
, then the cone will become detached, resulting in
severe rotor damage while turning at high speeds!
Ensure that the three protrusions on the nose cone are
evenly fastened to the hub as shown in the image
below.
9.