3. Remove the 2 screws that hold the gear housing
and motor in the chassis.
4. Remove the gear housing and motor from the
chassis.
5.6.2 To assemble the gear housing and motor in
the chassis
1. Put the gear housing and the motor in the left half of
the chassis. Make sure that the motor cables are put
in position (A) at the air holes in the chassis. Make
sure that the cables are put in the groove (B) above
the control unit.
A
B
B
B
CAUTION: Make sure that the cables do not
get damaged when the gear housing and
the motor are put on top.
2. Connect the gear housing and the motor in the
chassis with 2 screws.
3. Connect the plug from the motor to the control unit.
Attach the plug with the gray cable in position (C).
C
CAUTION: Make sure that the cables hang
straight down from the plug.
4. Assemble the right half of the chassis and the front
To remove the front handle on page 9
To disassemble the chassis on page 8.
5.7 Gear, cutting unit and gear housing
5.7.1 To disassemble the gear, cutting unit and
motor out of the gear housing
1. Remove the 6 screws and remove the bottom plate
of the gear housing.
2
3
6
4
5
1
2. Remove the 2 screws and remove the gears and the
cutting unit from the gear housing.
Note: The front screw locks also the safety point with
the related nut.
12 - Repair instructions
620 - 002 - 29.01.2019
Содержание BHT250PD60
Страница 1: ...Workshop manual BHT250PD60 English 620 002 29 01 2019...
Страница 26: ...26 Technical data 620 002 29 01 2019...
Страница 27: ...620 002 29 01 2019 Technical data 27...
Страница 28: ...www zenoah com 114 04 71 26 2019 01 30...