![background image](http://html1.mh-extra.com/html/zenoah/bht250pd60/bht250pd60_workshop-manual_3405385013.webp)
5.7.2 To disassemble the gears
1. Remove the circlip (A), remove the washer (B),
carefully lift up the hook (C) and remove the cutting
unit.
A
C
B
2. Disconnect the parts as shown in the illustration.
5.7.3 To assemble gears, cutting unit and motor in
the gear housing
Note: Lubricate moving parts on gears and the cutting
unit with grease so they move easily.
Note: Always replace the gasket after you disassemble
the gear housing.
1. Put the motor on the gear housing.
2. Put the gear and cutting unit in the gear housing.
Attach the cutting unit into the gear housing with 2
screws. Note that the front screw also locks the
safety point with the related nut. Tightening torque
3~4 Nm.
3. Assemble the bottom plate with gasket on the gear
housing and connect with 6 screws. Tighten the
screws crossways and refer to the number on the
bottom plate. Tightening torque 3 ~4 Nm.
2
3
6
4
5
1
620 - 002 - 29.01.2019
Repair instructions - 13
Содержание BHT250PD60
Страница 1: ...Workshop manual BHT250PD60 English 620 002 29 01 2019...
Страница 26: ...26 Technical data 620 002 29 01 2019...
Страница 27: ...620 002 29 01 2019 Technical data 27...
Страница 28: ...www zenoah com 114 04 71 26 2019 01 30...