Z35
http://www.zennio.com
Tecnical Support:
http://support.zennio.com
64
Cyclical
[
disabled
/enabled
]
:
sets whether scrolling through the speed levels is
circular or not. If checked, an increase order in the maximum level switches to
the minimum and vice versa (in the minimum level a decrease order switches to
the maximum).
Auto Mode
[
disabled
/enabled
]
:
sets whether the fan Auto mode will be available
or not. If checked, the following parameters are also shown.
Dedicated Object for Auto Mode:
sets how the Auto mode should be
activated. In the absence of a dedicated object, the Auto fan mode will be
activated by switching to fan level 0.
Figure 56.
[Climate] Fan
– Auto mode.
In this case (supposing that Speed Levels has been set to “3”), the fan levels
that can be navigated through short presses are:
Auto ( 0 )
Minimum
Medium
Maximum
On the other hand, marking the checkbox enables the 1-bit object
“[Pn][Bi]
Fan Control
– Auto Mode”
, which will trigger the
Auto mode
when it receives
the corresponding value (
Value to Set Auto Mode
[
Send 0
/ Send 1
])
.
Figure 57.
[Climate] Fan
– Dedicated Object for Auto mode.
However, two alternative (and mutually exclusive) methods are possible to
activate this mode: