MAXinBOX FC 0-10V FAN
http://www.zennio.com
Technical Support:
http://support.zennio.com
14
14
2.4
0-10V ANALOGUE OUTPUTS
MAXinBOX FC 0-10V FAN incorporates
two analogue voltage outputs
that provide a
voltage signal in the range 0 to 10 VDC. This voltage will be in accordance to the
percentage values that are received through a specific communication object
.
Each analogue output can be enabled or disabled in parameters, and is intended to
control the fan speed of one fan coil unit.
One on-board
LED indicator
is offered per output to show the status: it will remain off
while the output signal is 0V, and on while it is 10V. Under intermediate values, it will
blink with variable rates (according to the voltage).
ETS PARAMETERISATION
After enabling “
0-10V Analog Outputs
” in the General screen (see section 2.1), a new
tab will be incorporated into the tree on the left.
Figure 5
0-10V Analog Outputs - Configuration.
The two analogue outputs can be activated independently by marking the checkboxes.
This also brings new tabs to the tree.
Figure 6
0-10V Analog Output X
– Configuration.
