KEM
Technical Support:
15
Note:
Both objects are generic for all quantities (electricity, water and heat
quantity)
.
➢
“[Elec][Phx][PRn] Consumed Active Energy”.
(See section 2.2.2.2).
In addition, a new tab will
appear under “General” tab, where is possible to set
periodic resets
of the enabled partial registers. For more information see
section 2.1.2.
Show Global Objects
[
enabled /
disabled
]: this parameter enables the global
objects where the accumulated energy consumption data is stored.
Figure 6.
Electricity - Configuration - Global objects
➢
Power Units
[
W
/ kW
]: sets the measurement units of the global power
objects.
➢
Energy Units
[
Wh
/ kWh
]: sets the measurement units of the global energy
objects.
➢
Sending Mode for Power
[
Disabled
/ Periodic / With Value Change /
Periodic and with Value Change
]: sets when global power objects should be
sent. Depending on this selection, some more parameters will be available:
•
Period
[
30…255
][
s
] / [
1…
10
…255
][
min
/ h
]: sets the period between
cyclical sendings.
•
Minimum Time Between Sendings
[
10
…255
][s]: sets a minimum
period of time (seconds) between consecutive sendings.
•
Minimum Change to Send
[
[
1…
10
…15300][
W
] / [
1…15][kW]
]: sets the
minimum value change required to send the next value.