ALLinBOX 161
/ 88 / 46 / Hospitality
Technical Support:
8
1.3
START-UP AND POWER LOSS
During the start-up of the device, the Test/Prog. LED will blink in blue colour for a few
seconds before ALLinBOX is ready. External orders will not be executed during this time,
but they will do it afterwards.
Depending on the configuration, some specific actions will also be performed during the
start-up. For example, the integrator can set whether the output channels should switch
to a particular state and whether the device should send certain objects to the bus after
the power recovery. Please consult the next sections of this document for further details.
On the other hand, when a bus power failure takes place, ALLinBOX will interrupt any
pending actions and will save its state so it can be recovered once the power supply is
restored.
For safety reasons, if a power loss takes place, all
shutter channels
will be stopped
(i.e., the relays will open), while the individual outputs and fan coil contacts will switch to
the specific state configured in ETS (if any).
