ALLinBOX 161 /88 / 46 / Hospitality
Technical Support:
34
Disabled output
: short and long presses will switch the state of the
corresponding relay. In case this consists in closing the relay, then the
remaining relays of its block will open, for safety reasons.
As described previously if the device is in Test On mode, any command sent from the
KNX bus to the actuator will not affect the outputs and no status objects will be sent (only
periodically timed objects such as Heartbeat or logic functions will continue to be sent to
the bus) while Test ON mode is active. However, in the case of the "Alarm" and "Block"
objects, even though in Test ON mode the actions received by each object are not taken
into account, the evaluation of their status is carried out when exiting this mode; so that
any change in the alarm status or blocking of the outputs while Test ON mode is active is
taken into account when exiting this mode and is updated with the last status detected.
ETS PARAMETERISATION
When the option
“
Manual Control with IR
” is enabled in the “General” screen (see
section 2.4), a tab will be shown in the tree on the left.
The only two parameters are:
Figure 17.
Manual Control
Manual Control
[
Disabled /
Test On Mode
]: depending on the selection, the
device will permit using the manual control under the Test On or have it
disabled. Note that, as stated before, using Test On mode does require long
pressing the Prog/Test button.
Manual Lock Control
[
disabled
/enabled
]: unless the above parameter has
been “Disabled”, the Lock Manual Control parameter provides an optional
procedure for locking the manual control in runtime. When this checkbox is
Important
:
the device is factory delivered with all the output disabled, and with
manual control Test On mode enabled
.
