Zenith Presentation H27E46DT, Инструкция по установке и эксплуатации, Гарантия

Страница: 40 / 60

P A G E 4 0
206-3492-O
Item Description Range Fact. Set Recommended Setting
00 FACT MENU 0 - 1 0 Leave default set 0
01 PRESET PX 0 - 1 1
02 PRESET AX 0 - 1 1
03 POWER MANAGE 0 - 7 0
04 VERT POS 0 - 30 15
05 HORZ POS 0 - 45 15
06 BAND/AFC 0 - 7 0
07 MIN VOLUME 0 - 63 0
08 MAX VOLUME 0 - 63 63
09 AC ON 0 - 1 0
10 KEY DEFEAT 0 - 1 0
11 STRT CHANNEL 0 - 255 255
12 STRT VOLUME 0 - 63, 255 255
13 NOT USED 0 - 1 0 Leave default set 0
14 CHAN LOCK 0 - 1 0
15 GHOST CH. 0 - 1 0
16 NOT USED 0 - 3 0 Leave default set 0
17 TEXT MODE 0 - 1 1
18 SLEEP TIMER 0 - 1 1
19 ALARM 0 - 1 1
20 CH. OVER RIDE 0 - 1 1
21 OLD OCV 0 - 1 0
22 CAPTION LOCK 0 - 1 0
23 FUNCTION PRE 0 - 1 0
24 FEATURE LEVEL 0 - 1 1 Zen 1/0 P Lbl Leave default set 1 (1 Zen 1)
25 NTSC SCAN CARD 0 - 1 0
26 NOT USED 0 - 1 0
27 MUTE DISABLE 0 - 1 0
28 V-CHIP 0 - 1 1
29 MAX BLOCK HOURS 0 - 99 12
30 STRT AUX SRCE (0)/1-5/255 255
Installer Menus
Use the Installer Menus to change operational settings
1391-P07 01.47 02
4 VERT POS 13
XX/XX/XX TE = 10110000
Accessing the Installer’s Menu
Installer’s menus can be accessed by using the installer’s remote control. Just press
and hold MENU (about 8 seconds) until the display changes, then press 9, 8, 7, 6,
then ENTER. To exit the Installer’s Menu, press ENTER again.
Any changes you make
will be stored in nonvolatile memory.
The Installer’s Menu opens with item 04, VERT POS. Press the SELECT key to sequence
through the various items. Or, access an item directly by entering the line number,
then pressing MENU. For example, to access the Start Channel option which is on line
11, press 11, then MENU. To change a setting use the Left/Right ADJ keys.
Using the Installer’s Menu
Items 00-30 are immediately accessible only upon entering the Installer’s Menu.
Their numbers, descriptions, ranges, factory default settings, and a place for listing
any changes made on-site are given below. A second section of the Installer’s Menu
that is intended for qualified service technicians only is not shown (items 31-219).
Normally these items do not require adjustment.
Items in the Installer’s Menu:
Installer should leave item
00 FACT MENU set to 0
(default).
Items 31-219 are
service-type adjustments and
only qualified technicians having special-
ized test equipment should access them.