Zenith HDV420, Инструкция по установке и эксплуатации, Гарантия

Страница: 11 / 36

PREP
ARA
TION
11
Connections (Continued)
Connecting to a HD monitor (YPbPr type)
11
Connect the “Antenna” to the “ANT IN” jack on the HDTV Receiver using a coaxial RF cable.
ote
There might be some areas where the signal strength could is too high. If so, you may need to connect the antenna
to an attenuator and screw the attenuator onto the “ANT IN” jack. (Refer to page 9.)
2 2
Connect the “ANT LOOP OUT” jack on the HDTV Receiver to the “ANT IN” jack on your TV using a coaxial RF
cable.
3 3
Connect the “COMPONENT OUT” jacks on the HDTV Receiver to the “COMPONENT IN” jacks of your TV
using RCA-type cables. (The OUTPUT SELECTION switch must be set to YPbPr.)
4 4
Connect the L/R “AUDIO OUT” jacks on the HDTV Receiver to the L/R “AUDIO IN” jacks on your TV using
RCA-type cables.
ote
The component out jacks are available when 480p, 720p, or 1080i display format is selected.
Cable TV
wall jack
OR
L R
Y Pb Pr
COMPONENT VIDEO INPUT AUDIO INPUT
L
VIDEO
INPUT
S-VIDEO
INPUT
ANTENNA
INPUT
Rear of HD Ready TV
Rear of HDTV Receiver
Antenna