Zenith HDV420, Инструкция по установке и эксплуатации, Гарантия

Страница: 12 / 36

12
Connections (Continued)
Connecting to a HD monitor (RGB type)
11
11 Connect the “Antenna” to the “ANT IN” jack on the HDTV Receiver using a coaxial RF cable.
ote
There might be some areas where the signal strength could is too high. If so, you may need to connect the antenna
to an attenuator and screw the attenuator onto the “ANT IN” jack. (Refer to page 9.)
2 2
Connect the “ANT LOOP OUT” jack on the HDTV Receiver to the “ANT IN” jack on your TV using a coaxial RF
cable.
3 3
Connect the “RGB OUT” jack on the HDTV Receiver to the “RGB IN” jack of your TV using VGA-type connec-
tor. (The OUTPUT SELECTION switch must be set to RGB.)
4 4
Connect the L/R “AUDIO OUT” jacks on the HDTV Receiver to the L/R “AUDIO IN” jacks on your TV using
RCA-type cables.
ote
The RGB OUT jack is available when 480p, 720p, or 1080i display format is selected.
Cable TV
wall jack
OR
L R
AUDIO INPUT RGB INPUT
L
VIDEO
INPUT
S-VIDEO
INPUT
ANTENNA
INPUT
Rear of HD Ready TV
Rear of HDTV Receiver
Antenna