Zener SMARTSTART 6000 Series, Руководство пользователя

Страница: 19 / 43

Programming
Technical Manual: Smartstart
®
6000 IMI0042 rev D
Page 16
Menu Navigation
Note: to change any parameters the SS6000 must be
disabled. Remove the link in the Enable input (term.
14) or the external enable circuit.
The Main Menu
D01 Menu Access:
Sets the desired user access to menu
Selection: Disabled; Setup; Read only
Default:
Setup
To save changes
To exit without saving
If the menu access is disabled a user access code
is required to access the menu. The access code
is 1470.
D02 Default Screen:
The default screen is the dashboard screen that
the Soft Starter will return to - on power up, exit
or time-out from the menu.
Selection: Overview; Thermal; Electrical; Power;
Volt imbal; Curr imbal; Counters;
meters
Default: Overview
To save changes
To exit without saving
D03 Bargraph Var.:
Sets the bargraph variable to monitor & Display.
Selection: Mtr current; Mtr Torque;
Mtr Thermal; SCR Thermal; Active
Power; Power Factor
Default: Mtr Current
To save changes
To exit without saving
D04 Bargraph FS.:
Adjust the full scale of the bar graph meter as a
percentage.
Selection: 100;120;150;200;300;400;600
Default:
300%
To save changes
To exit without saving
Setup Menu
1 Display
MENU ACCESS
Read Only
LOGIN CODE
> 1470
3 sec
* Press <Enter> for
3 seconds.
Setup Menu
1 Display
Esc
Setup Menu
2 Motor
Setup Menu
3 Control
Off 0V
0%
Setup Menu
4 Protection
Setup Menu
5 Inputs
Setup Menu
6 Outputs
Setup Menu
7 Resets
Setup Menu
8 Advanced
Setup Menu
9 Commands
Dashboard screen (1 of 8)
Enter
Refer to Page 16
Refer to Page 17
Refer to Page 17
Refer to Page 18
Refer to Page 22
Refer to Page 21
Refer to Page 23
Refer to Page 23
Refer to Page 25
Setup Menu
10 Starter Diag
Refer to Page 25