Zena 150 series, Руководство оператора

Страница: 13 / 38

ZENA mobile welding system -- Operators Manual -- Series 150 & 200 Welders
7 7
IV. ZENA Welder Specifications
Power Output @
100% Duty Cycle 150 amps.
Typical Voltage Output
@ Full Power
w/Arc Established 20-24VDC w/High
Frequency Waveform
Modulation (Typically 700 modulation transitions per
second)
Typical Voltage Output
@ Full Power
w/NO Arc Established 58-78VDC w/High
Frequency Waveform
Modulation (Typically 700 modulation transitions per
second)
Min. Power Generator
Shaft Speed for
Maximum Output
Power approximately
6,500 RPM (Higher shaft speeds – up to 15,000 rpm -
have no detrimental effect on welding
performance, but welding at these speeds
requires larger drive pulley diameters)
DC Power Required
(When Welding) 11-14.5 volts @
7 amps. maximum (1 to 4 amps at average welding power
settings)
DC Power Required
(When NOT Welding) None
Control Circuit
Protection Internal Fuses (2) (2 amp. & 10 amp.)
Welding Controls Internal, Solid State (Built into electrode holder/welding cable
assembly)
Accessory Controls Internal (2)
SR150.12 welding power generator with WC12 control module