Zeiss S100/OPMI pico, Инструкция по эксплуатации

Страница: 211 / 278

Version 7.0
G-30-1781-en
Page 211
S100 / OPMI pico What to do in the event of malfunctions
Light source (surgical field illu-
mination) disabled Power cord not plugged in. Plug in the power cord. Page 108
Power switch not pressed. Press power switch. Page 108
Defective power cord. Replace the power cord. –
Power failure. Contact in-house technician. –
Defective instrument fuse. Change instrument fuse. Page 228
(Halogen)
Failure of suspension elec-
tronics. Illuminate surgical area with
an OR luminaire. Contact
service. –
Light guide not properly in-
serted in lamp or microscope. Insert light guide as far as it
will go. Page 98
Switched off via inclination
switch on suspension system. Move suspension arm of sus-
pension system into working
position. –
Light source (surgical field illu-
mination) defective Brightness level set too low. Adjust brightness using
brightness control on suspen-
sion arm. –
Light guide not properly in-
serted in lamp and/or micro-
scope. Insert light guide as far as it
will go. Page 98
Defective light guide (illumi-
nation not uniform). Contact service. –
For xenon light sources:
Old xenon lamp. Disable light source on stand.
Change xenon lamp. Page 226
For LED light source:
LED light source with limited
operating mode. Contact service. –
Problem Possible cause Remedy Cross-
reference