Zeiss S100/OPMI pico, Инструкция по эксплуатации

Страница: 102 / 278

Preparations for use S100 / OPMI pico
Version 7.0
Page 102 G-30-1781-en
Mounting documentation accessories on the MORA interface with lateral out-
put port
Requirement  The MORA interface with lateral port for documentation accessories has
been mounted on the surgical microscope.
The method described below can also be used for other accessories. The op-
erating principle of the accessories is described in the relevant Instructions for
Use.
Attaching documentation
accessories
• Loosen knurled ring (2). An arrow with the labeling "open" is located on
the shaft next to knurled ring (2).
• Remove dust cover (3) and store it in a safe place.
• Slide the accessories (4) in the image exit port holding fixture .
The mount of the image exit port is fitted with guide projections. Acces-
sory (4) has the corresponding grooves.
• Carefully turn the accessory module until the guide projections fit into the
grooves,
• and slide the accessory in the mount as far as it will go.
• Screw knurled ring (2) onto accessory module (3).
• Firmly tighten knurled ring (2).
If the accessory is mounted with the connector pointing vertically up-
wards, the image of the connected camera will be displayed with a 90°
rotation.
• To avoid this, you can mount the accessory rotated by 90° so that the con-
nector (incl. camera) points horizontally to the back.
• Note the effect of annular diaphragm (1) swung into the beam path.
Fig. 53: Mounting documenta-
tion accessories on the
MORA interface with lateral
output port
2 4 3 1