SM-30-0030-A02
Confidential and Proprietary
Service Instructions
Version 07, 2015-12-03
19 / 27
Order No. -
6)
Disconnect cables (
1 + 2
) and remove them
from the illumination unit.
7)
Cut open the cable ties and remove the cable
from the rear tube.
8)
Pull the cables out of the suspension arm joint
in an upward or downward direction.
Fig. 32: Disconnect cables
9)
Remove stop screw / screws (
5
)
10)
Remove two C-clips (
3
), washer
4
) and pull out
the suspension arm from the rear tube bearing.
Installation:
1)
Insert the new suspension arm in the rear tube
bearing and secure it in position using
washer (
4
) and two C-clips (
3
).
Fig. 33: Remove stop screw, C-clips, washer
2)
Pull the cables through the arm joint in an
upward or downward direction.
3)
Fasten the cables to the rear tube using cable
ties.
4)
Route the light guide and the video cable in the
suspension arm and re-attach the cable conduit.
5)
Pull cables (
1 + 2
) into the illumination unit and
plug them in.
6)
Re-attach the cover or the camera control unit.
7)
Insert OPMI®.
8)
Balance the suspension arm.
9)
Adjust inclination switch (
Fig. 34: Connect cables
1 2
3
4
5
1 2
