ZEISS
Start-Up and Operation
Primovert
38
415510-7244-001
12/2014
Date / Time
Date and time in year-month-day / hour-minute-second format.
Each element can be adjusted using the up / down buttons. The new time can be set by pressing
the
OK
button. Date and time are integrated into the folder and file names on the SD card.
Flip image
The following modes are available for image mirroring:
FLIP H+V:
horizontal and vertical mirroring
FLIP V:
only vertical mirroring
FLIP H:
only horizontal mirroring
OFF:
no mirroring
Default setting: the image position on the monitor or iPad corresponds to that in the eyepiece.
Load Settings
The previously saved user settings (USER 1-4) can be loaded in this menu.
Selecting
FACTORY DEFAULT
reinstates the default camera settings. After confirmation with OK
the camera will be restarted. This may take several seconds.
If the OSD menu is not available, the factory settings can be reinstated using the short-cut
Snap
+
AWB / OK
(keep depressed for two seconds).
Save Settings
The current settings can be saved in a user storage location (USER 1-4).
They can be automatically loaded in the
Load Settings
(see above) or
Startup Set
menus (see
below) at a later point in time or each time the camera is switched on
Please observe the following: If the settings are saved,
Startup Set
is automatically set to this
storage location.
Startup Set
This setting determines which user storage location (USER 1-4) is to be loaded each time the
camera is switched on.
Version
Current firmware version
MAC
MAC address of the built-in camera
IP
Currently used IP address
Destination IP
Currently used multicast target address
Netmask
Currently used netmask
Fig. 26
Setup User menu
Fig. 27
Technical Info menu
