LSM 510
QUICKSTART
LSM 510 META
Switching on the System
Carl Zeiss
B 45-0008 e 10/02
4-7
4.2
Switching on the System
The LSM system is turned on with the
REMOTE CONTROL
switch. This switches all the system
components on except for the "Enterprise" UV laser.
If the UV laser shall be used, it can be switched on after the start of the WINDOWS ® NT operating
system - but must always be switched on before the LSM 5 software is started.
If
REMOTE CONTROL
switch is not used, turn the system on with the "
I
" button on the laser module;
in addition, the jumper plug supplied must be connected to the
POWER REMOTE CONTROL
terminal.
•
Turn the
REMOTE CONTROL
switch to "
ON
"
position (see Fig. 4-1).
−
This switches the entire system on.
−
Microscope and laser will be ready for
operation after a short time.
−
Computer boots up.
−
Computer hardware system test runs.
Drive "A" of the computer must not
contain a floppy disk.
The monitor shows a dialog box for selection of
the operating system version.
Fig. 4-2
Selecting the operating system version
Fig. 4-1
REMOTE CONTROL switch
Содержание LSM 510 META
