Zeiss KSK 150 FC, Инструкция по эксплуатации

Страница: 69 / 92

Version 7.1
G-30-1158-en
Page 69
KSK 150 FC System Data
Illumination equipment Lamp housing in carrier arm: Halogen reflector lamp
12 V 100 W, manual lamp change. An integrated
fiber optic system (light guide) directs the light to the
colposcope.
Power connection Power connector on carrier arm: Only connect the
device to wall outlets which are properly equipped
with a protective ground conductor.
Rated voltages,
adjustable
100/110/120/127/220/230/240 V
Rated frequency 50Hz - 60Hz
Power consumption 200 VA (nominal)
Fuses See section on "Spare parts", Page 75
Electrical standard Degree of protection IP X0 according to
IEC 60529:1989+A1:1999+A2:2013
The system has been designed for continuous operation.
Load For an asymmetric load distribution on the colpo-
scope body, maximum 2.1 kg, i.e., adaptation of the
beam splitters, tubes, eyepieces, camera adapters,
etc. on one side. The asymmetric load distribution is
limited by the maximum load permissible on the tilt
joint in the instrument head.
When the load is distributed symmetrically on the
body of the colposcope, maximum 3.3 kg, i.e., adap-
tation of a micromanipulator on one side and adap-
tation of beam splitters, tubes, eyepieces, cameras,
etc. on the other. The symmetric load distribution is
limited by the maximum load permissible on the sus-
pension arm.
Device base of the colposcope floor stand
Weight Approx. 39 kg
Column length Approx. 0.65 m
Maximum total weight Max. 60 kg (Colposcope floor stand with installed
safe workload)
Component Properties