START-UP
Axioskop 2 FS
plus
Carl Zeiss
Initial start-up
Axioskop 2 FS
MOT
2-6
B 40-076 e 02/01
2.1.2
Remove transport lock and
carrying handle
To exclude damage to the precision objective
focusing drive during transport, the
Axioskop 2 FS
plus
/ FS
MOT
microscopes are
equipped with two safety screws and a carrying
handle. When the microscope has been set up,
these items must be removed.
•
Remove both safety screws (2-2/
1
) using a
SW 3 ball-headed screwdriver.
•
Remove all adhesive tapes, including those at
the drive knobs.
•
Use SW 3 ball-headed screwdriver to loosen
both fixation screws (2-1/
1
) of the carrying
handle bases (2-1/
3
) and remove the carrying
handle (2-1/
2
) with bases from the stand.
After removal of the safety screw, the microscope must not be held at the objective slider to
lift it for a change of position, since this will damage the mechanical components of the
focusing drive.
For the Axioskop 2 FS
plus
MOT
, please observe the note at the rear of the stand concerning
the removal of a further transport lock.
Fig. 2-2
Remove transport locking device
Содержание Axioskop 2 FS mot
