INTRODUCTION
Carl Zeiss
Equipment safety notices
Axio Examiner
10
M60-2-0003 e 05/2012
Gas discharge lamps as, e.g., HBO 100 emit ultraviolet radiation which might cause burning to
the eyes and to the skin. Accordingly, do not look directly into the light source, and avoid any
direct incidence of light on your skin. Whenever working on the microscope, always use the
protection devices belonging to the equipment (e.g., specific attenuating filters or the
fluorescence protection screen). Gas discharge lamps are under a high internal pressure when
hot. Accordingly, they should only be replaced after having cooled down, and using both
protective gloves and a protective mask.
When using a fluorescence filter, do not remove the heat filter for protection against the heat
radiation emitted by the microscope lamp since fluorescence filters are heat sensitive, and heat
may impair proper functioning.
Avoid touching the hot lamp housing. Prior to lamp replacement, unplug the power plug from
the corresponding power supply unit, and allow approximately 15 minutes for the lamp to cool
down.
Dust and contamination may impair the equipment's operational reliability. So, the equipment
should be protected against any such influence as far as possible. Cover the equipment with
the dust cover whenever it is not in use. Before covering the equipment, always check that all
lighting devices have been switched off.
Clogged or covered venting slots may lead to heat buildup which may damage the equipment
and even cause a fire in extreme cases. Venting slots should always be kept free and open, and
no object should be inserted or allowed to fall in.
This equipment must not be operated unless by duly instructed personnel. Such personnel must
be instructed about possible hazards related to microscopy and to the corresponding field of
application. Axio Examiner microscopes are precision instruments, and their operability may be
impaired, or the equipment may be destroyed by any inexpert treatment or intervention.
Make certain to read the safety data sheets for Immersol 518 N
®
and 518 F
®
.
Immersol 518 N
®
and 518 F
®
immersion oils are irritating to the skin. Avoid any contact with
skin, eyes, or clothing.
Wash with abundant water and soap in the event of any skin contact.
After eye contact, immediately rinse with abundant water for not less than 5 minutes. Consult
a specialist physician if irritation persists.
Appropriate disposal (Immersol 518 N
®
and 518 F
®
):
Do not allow to be discharged into surface waters or sewage drains.
Defective microscopes do not belong into household waste; they should be disposed of
pursuant to statutory provisions.
Specimens should also be disposed of according to good professional practice, observing both
the applicable statutory provisions and in-house work instructions.
Содержание Axio Examiner
