- 2 -
- each curve can be set in 4 to 15 curve points
- 3D interpolated ignition map, if TPS selected
- signal delay compensation
- instant monitoring of rev's and angle, via LCD(hand held programmer)
- programmable power valve actuation
- store and load function for 8 PV curves
- external switch for changing PV curve while riding
- programmable PV deviation
- programmable max close and max open positions
- self PV test on power-up
- PV error detecting (position sensor failure, servo motor failure)
- fast processing for high accuracy - delays from 1us
- timing calculation for every 1 RPM change (1000, 1002, .. , 9805, 9806, ...)
Very important!
Resistor spark plugs must be used, because they produce less electromagnetic
disturbances.
Danger of electric shock!
Avoid connecting PDCI to 12V power supply, before connecting to ignition coil. High
voltage is generated and touching free wires can cause electric shock, or damage the
unit.
1.
HOW TO ENTER MENU
Connect
programmer
to
PDCI
and wait few seconds for activation of
programmer
and
press
'
ENTER
'
.
Move through menu with pressing
'
+
'
, or
'
-
'
and select with pressing
'
ENTER
'
.
Exit menu with selecting
Exit.
2.
MENU ORGANIZATION
Set Ign.
- ignition parameters submenu
Set PV
- PV parameters submenu
Exit
2.1.
SET IGNITION PARAMETERS SUBMENU
Load Ign. Map
- load (select) ignition map
Save Ign. Map
- save new ignition map
Set Ignition Map
- ignition map parameters submenu
Advance
- advance/retard whole ignition map on both ignition coil outputs
Advance 1
- advance/retard ignition coil output 1
Advance 2
- advance/retard ignition coil output 2
Gear Shift Light
- shift light
Quick Shift
- quick shift settings
