Procedure
Step 1
Remove cable glands from the positive and negative connectors.
Figure 4-25 Connecting DC input power cables
Step 3
Insert the positive and negative power cables into corresponding cable glands.
Step 5
Insert crimped power cables into corresponding housings until you hear a "click" sound.
The power cables snap into place.
End
Figure 4-26 Connecting DC input power cables
1. Positive power cable 2. Negative power cable
L2 is 2 to 3 mm longer than L1.
Note
Step 2
Remove the insulation layer with an appropriate length from the positive and negative
power cables by using a wire stripper as show in Figure 4-26.
Step 4
Insert the stripped positive and negative power cables into the positive and negative
metal terminals respectively and crimp them using a clamping tool. Ensure that the cables
arecrimped until they cannot be pulled out by force less than 400 N, as shown in Figure 4-27.
1. Positive power cable
2. Negative power cable
Step 6
Reinstall cable glands on positive and negative connectors and rotate them against the
insulation covers.
Step 7
Insert the positive and negative connectors into corresponding DC input terminals of
the 20~33KTL-G2 until you hear a "click" sound, as shown in Figure 4-28.
Figure 4-27 Connecting DC input power cables
1. Bayonet
39
40
20~33KTL-G2
User manual
20~33KTL-G2
User manual
