5
D: DISPENSING WATER
This unit has been tested and sanitized prior to packing and shipping. During transit dust and odors
can accumulate in the tank and lines. Dispense and dispose at least one quart of water prior to
drinking any water.
Dispensing Warm or Cold Water
1.Water will take approximately 1 hour after initial set up to become completely chilled. Cooling light
will turn off once the water has been fully chilled.
2.Press cold/warm water button to dispense cold/warm water
3.Release button once desired fill level is achieved.
Dispensing Hot Water
1.Water will take approximately 12 minutes after initial set up to reach its hottest temperature. Heating
light will turn off once the water has been fully heated.
2.This water dispenser is equipped with a child safety feature in order to prevent inadvertent
dispensing. To enable dispensing of hot water, press the child lock button first, then press the hot
water button.
3.Release button once desired fill level is achieved.
CAUTION:
This unit dispenses water at temperatures that can cause severe burns. Avoid direct
contact with hot water. Keep children and pets away from the unit while dispensing. Never allow
children to dispense hot water without proper and direct supervision, Disable the heating feature by
switching the heating convenience switch.
Touchless control function
Place the hand 2 inches over the sensor to dispense cold water. When you take you hand away
from the sensor, the water stops. The continuous water dispensing time is up to 30 seconds by
default setting when you keep your hand over the sensor.
Setting model:
Press the child lock button and hot water button together for 3s, the child lock button and cold water
button light flash. The machine enters setting mode. You can reset the continuous dispensing time
by putting your hand over the sensor within 10 seconds. The machine starts dispensing cold water
till you take your hand away or 40 seconds. The machine will remember this timing as continuous
dispensing time.
If you don’t take any action in 10 seconds after the machine enters setting mode, the child lock
button and cold water button light flash will stop flashing and the touchless control function is
inactivated.
To activate the touchless control function, you need to enter the setting mode again and set the
continuous dispensing time. Power off the machine will resume to default setting.
Changing Bottles
A flashing red light on your function lights alerts you when your bottle is empty. Replace the bottle as
soon as possible
Notice: Do not dispense hot or cold water if the red light is flashing as you could empty the tanks
and cause the dispenser to overheat.
1.Open dispenser door.
2.Slide empty bottle out of cabinet.
3.Remove probe assembly from empty bottle. Place probe assembly on probe hanger.
4.Set empty bottle aside.
5.Place fresh bottle outside of cabinet. Remove entire plastic cap from top of bottle. Clean outside
of new bottle with a cloth.
6.Place probe into bottle. Slide collar down until it clicks in place. Push head down until tubes hit
bottom of bottle.
7.Slide bottle into cabinet and close door.
