6
E: TROUBLE SHOOTING
F: CLEANING
Water is leaking.
•Unplug dispenser, remove bottle and replace it.
No Water is coming from the spout.
•Make sure the bottle is not empty. If empty, replace it.
•Make sure to completely depress the pushbutton controls.
Cold water is not cold.
•It takes up to one hour after setup to dispense cold water.
•Make sure the power cord is properly connected to a working outlet.
•Make sure the back of the dispenser is at least 20cm from a wall and there is free airflow on all
20cm sides of the dispenser.
•Make sure green power switch on back of dispenser is ON.
•If water still isn’t cold, please ask for the service agent for assistance.
Hot water is not hot.
•It takes 15-20 minutes after setup to dispense hot water.
•Make sure the power cord is properly connected to a working outlet.
•Make sure red power switch on back of dispenser is ON.
Dispenser Is Noisy
•Make sure the dispenser is positioned on a level surface.
To avoid accident, cut off the power supply before operation according to the following instruction.
1.
The machine had been disinfected before departed from factory. Cleaning the dispenser prior to
install a full bottle of water for the first time.
2.
Cleaning and draining instruction:
a) Before cleaning, make sure the power switch in the O(off) position and unplug the water dispenser.
b)Twist out the two screws
①
, then take down top cover, cold tank cover and separator
②
.
c)Fill 0.6 gallons pure water into cold tank to clean it.
d)Place a large water bucket beneath the drain outlet which on the back of water dispenser, then
remove the drain cover and drain the water
③
.
e)Reposition the drain cover, separator, cold tank cover and top cover after draining. Ensure the pipe
and wires are connected properly , then, you can use the machine normally.
Attention:
1) The cleaning must be under the guidance of professional staff.
2)The dispenser heats water to a temperature of approximately 85
℃
. It can cause severe burns.
Please operate it carefully.
