7
G: MACHINE INSTALLATION
The packaging material used is recyclable; we recommend that you separate plastic,
paper and cardboard and give them to recycling companies. To help preserve the
environment, the refrigerant used in this product is R134a (Hydrofluorocarbon
-HFC), which does not affect the ozone layer and has little impact on
the greenhouse effect. According to WEEE (Waste of Electrical and
Electronic Equipment) guidelines, waste from electrical and electronic
devices should be collected separately. If you need to dispose of this
appliance in the future, do NOT throw it away with the rest of your
domestic garbage. Instead, please take the appliance to he nearest
WEEE collection point, where available.
3.Sanitizing
The machine should be disinfected with the disinfectant separately bought from drugstore or
marketplace according to the instruction manual of the disinfectant and then clean it with water (see
cleaning and draining instruction). Generally this should be done every three months.
4.To remove mineral deposits:
Mix 4 liters water with 200g citric acid crystals, inject into the machine and make sure the water can
flow out of the hot water tap. Switch on the power and heat it about 10 minutes, 30 minutes later,
drain off the liquid and clean it with water for two or three times. Generally this should be done every
six months.
Never disassemble this machine by yourself to avoid danger from damaged machine.
1-2. Loosen the screw of the left or right bottom angle just as the picture
shown.
3.Use the screw to fix the bracket on the left or right bottom angle of the
water dispenser.
4.Make a hole on the floor’s or the desk’s surface where the water
dispenser will be installed.
5.Fix the bracket on the floor by screw tightly.
6.Tighten the screw.
WARNING!
To avoid a hazard due to instability of the appliance, it must be fixed in accordance
with the instructions.
Water dispenser
Bracket
The hole for
tighten screw
5
6
